Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.
This is the free Material Data Center Datasheet of ALCOM 3D TCE PC 5020 16116 - PC-X20 - MOCOM Compounds GmbH & Co. KG
unit conversion, PDF datasheet print, comparison with other plastics, snap fit calculation, beam deflection calculation, CAE Interfaces
Check here, which other Alcom datasheets, application examples or technical articles are available in Material Data Center
Base Polymer | Polycarbonate |
Filler/Additive System | 20 % special filler |
Special Features | increased thermal conductivity,antistatic,heat stabilised |
Market Segment | Lighting,electrical and electronic |
Application Area | Extrusion of 3D printable FDM filaments |
Typical Applications | functional components |
기계적 특성 | 값 | 단위 | 시험규격 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
ISO 데이터 | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
인장탄성률 | 2450 | MPa | ISO 527 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
챠피 충격 강도 , +23°C | 60 | kJ/m² | ISO 179/1eU | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
챠피 노치드 충격 강도, +23°C | 8 | kJ/m² | ISO 179/1eA |
전기적 특성 | 값 | 단위 | 시험규격 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
ISO 데이터 | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
표면 저항 | 100 | Ohm | IEC 62631-3-2 |
기타 특성 | 값 | 단위 | 시험규격 |
밀도 | 1290 | kg/m³ | ISO 1183 |
Pre-Drying Conditions | in a dry air (dessiccant) dryer 100-120 °C for 2-3 h dependant on moisture content max. moisture content <0,02 % |
Processing Injection Moulding | Filament extrusion melt temperature 250-270 °C Recommendations for 3D print depending on printertype 3D print Nozzle temperature 300-320 °C 3D print Bed temperature 80-120 °C 3D print Print speed 10-60 mm/s Additional 3D Printing Surface recommended |
Storage | dry, protected from light |
Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.
Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.