Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.
This is the free Material Data Center Datasheet of ALTECH PA6 A 2035/509 GF35 LV - PA6-GF35 - MOCOM Compounds GmbH & Co. KG
unit conversion, PDF datasheet print, comparison with other plastics, snap fit calculation, beam deflection calculation, CAE Interfaces
Check here, which other Altech datasheets, application examples or technical articles are available in Material Data Center
Base Polymer | Polyamide 6 |
Filler/Additive System | 35 % glass fibres,heat stabilised |
Special Features | easy release (demoulding),good flow,improved surface appearance |
Typical Applications | injection moulded parts |
Механические свойства | сухой / конд | Единица | Стандарт | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Данные ISO | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Модуль упругости при растяжении | 10500 / - | МПа | ISO 527 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Напряжение при разрыве | 170 / - | МПа | ISO 527 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Удлинение при разрыве | 3 / - | % | ISO 527 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Ударная вязкость по Шарпи, +23°C | 80 / - | кДж/м2 | ISO 179/1eU | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Ударная вязкость по Шарпи с надрезом, +23°C | 12 / - | кДж/м2 | ISO 179/1eA |
Теплофизические свойства | сухой / конд | Единица | Стандарт | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Данные ISO | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Температура изгиба под нагрузкой, 1.80 МПа | 210 / * | °C | ISO 75-1/-2 |
Прочие свойства | сухой / конд | Единица | Стандарт |
Плотность | 1400 / - | кг/м³ | ISO 1183 |
Pre-Drying Conditions | 80 °C in a dry air (dessiccant) dryer for 2-12 h dependant on moisture content |
Processing Injection Moulding | melt temperature 270-290 °C mould temperature 80-100 °C |
Storage | dry, protected from light |
Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.
Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.