Complete Set of CAMPUS® Data, ASTM Data, Biopolymer Database, Application Database, Tradename Database, Literature Database, Toolbox.

Material datasheets available free. Online registration at: www.materialdatacenter.com

Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.

This is the free Material Data Center Datasheet of POLYfill PPHC GF3030 PD2 - PP-GF30 - Polykemi AB

Material Data Center offers the following functions for POLYfill PPHC GF3030 PD2:
unit conversion, PDF datasheet print, comparison with other plastics

Check here, which other Polyfill datasheets, application examples or technical articles are available in Material Data Center

Use the following short links to get directly to the properties of interest in this datasheet:
Any use of this information falls under the rules of our disclaimer.
Características de processamento/físicasValorUnidadeMétodo de ensaio
ISO Dados
Índice de fluidez, MFI 3 g/10min ISO 1133
Temperatura 230 °C -
Carga 2.16 kg -
Propriedades mecânicasValorUnidadeMétodo de ensaio
ISO Dados
Resistência à tração 65 MPa ISO 527
Deformação no escoamento 7 % ISO 527
Módulo de flexão, 23°C 4000 MPa ISO 178
Res. impacto Charpy c/entalhe, +23°C 12 kJ/m² ISO 179/1eA
Propriedades térmicasValorUnidadeMétodo de ensaio
ISO Dados
Temperatura de deflexão térmica, 1.80 MPa 125 °C ISO 75-1/-2
Temperatura de deflexão térmica , 0.45 MPa 150 °C ISO 75-1/-2
Temperatura de amolecimento Vicat , A 160 °C ISO 306
Temperatura de amolecimento Vicat, B 125 °C ISO 306
Flamabilidade a 1.5mm esp. nom. HB class IEC 60695-11-10
Espessuras do tubo de teste 1.6 mm -
Glow Wire Ignition Temperature (GWIT) 750 °C IEC 60695-2-13
GWIT - thickness tested (1) 2 mm -
Outras propriedadesValorUnidadeMétodo de ensaio
Densidade 1110 kg/m³ ISO 1183
Características
Processamento
Moldagem por injeção
Características
Reforço quimicamente acopladas
Disponibilidade regional
Europa, Ásia Pacífico
Disclaimer
Copyright Altair Engineering GmbH. Altair Engineering GmbH assumes no liability for the system to be free of errors. The user takes sole responsibility for the use of this data under the exclusion of every liability from Altair Engineering GmbH; this is especially valid for claims of compensation resulting from consequential damages. Altair explicitly points out that any decision about the application of materials must be double checked with the producer of this material. This includes all contents of this system. Copyright laws are applicable for the content of this system.
Created: Source: www.materialdatacenter.com


Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.

Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.