Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.

This is the free Material Data Center Datasheet of ALCOM PA66 910/1 PTFE20 - (PA66+PTFE) - MOCOM Compounds GmbH & Co. KG

Check here, which other Alcom datasheets, application examples or technical articles are available in Material Data Center

Propriedades mecânicas - Propriedades térmicas - Outras propriedades - Diagrama

Any use of this information falls under the rules of our disclaimer.

Informação do produto

Base Polymer	Polyamide 66
Filler/Additive System	20 % PTFE
Special Features	improved sliding / wear
Market Segment	Automotive,Machinery
Application Area	injection moulded parts
Typical Applications	functional components,bearings and sliding elements

Propriedades mecânicas	Seco / Cond	Unidade	Método de ensaio
ISO Dados
Módulo de tração	2900 / -	MPa	ISO 527
Tensão na ruptura	65 / -	MPa	ISO 527
Deformação na ruptura	6.3 / -	%	ISO 527
Resistência ao impacto Charpy , +23°C	70 / -	kJ/m²	ISO 179/1eU
Res. impacto Charpy c/entalhe, +23°C	3.5 / -	kJ/m²	ISO 179/1eA

Propriedades térmicas	Seco / Cond	Unidade	Método de ensaio
ISO Dados
Temperatura de deflexão térmica, 1.80 MPa	70 / *	°C	ISO 75-1/-2
Temperatura de amolecimento Vicat, B	235 / *	°C	ISO 306

Outras propriedades	Seco / Cond	Unidade	Método de ensaio
Densidade	1250 / -	kg/m³	ISO 1183

Diagrama

Características

Processamento

Moldagem por injeção

Características especiais

Estável contra o calor

Disponibilidade regional

América do Norte, Europa, Ásia Pacífico, America Centra e do Sul, Oriente/África

Outras informações

Moldagem por injeção

Pre-Drying Conditions	80 °C in a dry air (dessiccant) dryer for 2-12 h dependant on moisture content
Processing Injection Moulding	melt temperature 280-300 °C mould temperature 80-120 °C
Storage	dry, protected from light not above 30°C

Disclaimer

Copyright Altair Engineering GmbH. Altair Engineering GmbH assumes no liability for the system to be free of errors. The user takes sole responsibility for the use of this data under the exclusion of every liability from Altair Engineering GmbH; this is especially valid for claims of compensation resulting from consequential damages. Altair explicitly points out that any decision about the application of materials must be double checked with the producer of this material. This includes all contents of this system. Copyright laws are applicable for the content of this system.

Created: Source: www.materialdatacenter.com

Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.

Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.