Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.

This is the free Material Data Center Datasheet of ALCOM PA66 910/1 GF30 PTFE15 SI2 - (PA66+PTFE)-GF30... - MOCOM Compounds GmbH & Co. KG

Check here, which other Alcom datasheets, application examples or technical articles are available in Material Data Center

Propiedades mecánicas - Propiedades térmicas - Otras propiedades - Funciones

Any use of this information falls under the rules of our disclaimer.

Texto del producto

Base Polymer	Polyamide 66
Filler/Additive System	30 % glass fibres,15 % PTFE,2 % silicone
Special Features	improved sliding / wear,heat stabilised
Market Segment	Automotive,Machinery
Application Area	injection moulded parts
Typical Applications	functional components,bearings and sliding elements

Propiedades mecánicas	Seco / Cond	Unidades	Método de ensayo
ISO Data
Módulo de tracción	9500 / 6500	MPa	ISO 527
Resistencia a la tracción	150 / 114	MPa	ISO 527
Alargamiento a rotura	3.1 / 4.4	%	ISO 527
Resistencia al impacto Charpy, +23°C	70 / 70	kJ/m²	ISO 179/1eU
Resistencia al impacto Charpy c/entalla, +23°C	12 / 15	kJ/m²	ISO 179/1eA

Propiedades térmicas	Seco / Cond	Unidades	Método de ensayo
ISO Data
Estabilidad al calor, 1.80 MPa	255 / *	°C	ISO 75-1/-2

Otras propiedades	Seco / Cond	Unidades	Método de ensayo
Densidad	1480 / -	kg/m³	ISO 1183

Funciones

Características

Procesamiento y forma de entrega

Moldeo por inyección

Características especiales

Estable contra el calor

Disponibilidad regional

Norteamérica, Europa, Asia Pacifico, América del Sur y Centroaméric, Próximo Oriente/Africa

Demás información

Moldeo por inyección

Pre-Drying Conditions	in a dry air (dessiccant) dryer <80 °C for 2-12 h dependant on moisture content
Processing Injection Moulding	melt temperature 280-300 °C mould temperature 80-120 °C
Storage	dry, protected from light not above 30°C

Disclaimer

Copyright Altair Engineering GmbH. Altair Engineering GmbH assumes no liability for the system to be free of errors. The user takes sole responsibility for the use of this data under the exclusion of every liability from Altair Engineering GmbH; this is especially valid for claims of compensation resulting from consequential damages. Altair explicitly points out that any decision about the application of materials must be double checked with the producer of this material. This includes all contents of this system. Copyright laws are applicable for the content of this system.

Created: Source: www.materialdatacenter.com

Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.

Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.