Any use of this information falls under the rules of our
disclaimer.
Características de processamento/físicas | Valor | Unidade | Método de ensaio |
ISO Dados |
Índice de fluidez volumétrico, MVR |
18 |
cm³/10min |
ISO 1133 |
Temperatura |
190 |
°C |
- |
Carga |
2.16 |
kg |
- |
Other Standards[S] |
Contração após a moldagem, paralelo |
3.0 |
% |
|
S: | These properties are reported by the producer according standards that are different to our defaults. |
Propriedades mecânicas | Valor | Unidade | Método de ensaio |
ISO Dados |
Dureza Shore A |
88 |
- |
ISO 7619-1 |
Other Standards[S] |
Módulo de flexão, 23°C |
27 |
MPa |
ISO 6721-1 |
Módulo de flexão |
72 |
MPa |
ISO 6721-1 |
Módulo de flexão - Temperatura |
60 |
°C |
- |
S: | These properties are reported by the producer according standards that are different to our defaults. |
Propriedades térmicas | Valor | Unidade | Método de ensaio |
ISO Dados |
Temperatura de fusão, 10°C/min |
160 |
°C |
ISO 11357-1/-3 |
Temperatura de amolecimento Vicat , A |
90 |
°C |
ISO 306 |
Other Standards[S] |
Temp. de transição vítrea, 10 °C/min |
-13.6 |
°C |
ISO 6721-1 |
S: | These properties are reported by the producer according standards that are different to our defaults. |
Outras propriedades | Valor | Unidade | Método de ensaio |
Densidade |
1200 |
kg/m³ |
ISO 1183 |
Bulk density |
457 |
kg/m³ |
- |
3D Data | Valor | Unidade | Método de ensaio |
Other Standards[S] |
Resistência à tração, flat |
20[1] |
MPa |
DIN 53504 |
Resistência à tração, upright |
15[2] |
MPa |
DIN 53504 |
Deformação na ruptura, flat |
520[1] |
% |
DIN 53504 |
Deformação na ruptura, upright |
500[2] |
% |
DIN 53504 |
1: | XY-direction | 2: | ZX-direction | S: | These properties are reported by the producer according standards that are different to our defaults. |
Características
Processamento
Additive Manufacturing, Sinterização a laser
Forma de entrega
Pó, Branco
Aplicaciones
Equipo deportivo
Disponibilidade regional
América do Norte, Europa, Ásia Pacífico, America Centra e do Sul
Disclaimer
Copyright Altair Engineering GmbH. Altair Engineering GmbH assumes no liability for the system to be free of errors. The user takes sole responsibility for the use of this data under the exclusion of every liability from Altair Engineering GmbH; this is especially valid for claims of compensation resulting from consequential damages. Altair explicitly points out that any decision about the application of materials must be double checked with the producer of this material. This includes all contents of this system. Copyright laws are applicable for the content of this system.
Created: Source: www.materialdatacenter.com