Material datasheets available free. Online registration at: www.materialdatacenter.com
Mustang - Polyester - Plaskolite, Inc
Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.
A search for "Mustang" in Material Data Center leads to the following information:
|
|
Material Data Center offers information about the following products with the requested tradename. To view a datasheet, please click on the relevant product.
...t, Wilmington/Delaware, is a new grade of Zytel with high hydrolysis resistance. It was developed for a cooling-system connector made by ABA of Sweden for Visteon’s new HVAC cooling system used in the 2005 Ford Mustang GT and throughout the Ford C1 platform. DuPont (like Bayer and Rhodia) has also come out with special grades of Zytel nylon for water-assisted injection molding of automotive pipes. Hydrolysis resistance is important here, too, to prevent debonding of glass fibers from the resin m...
Kunststoffe international, 2005-11-21, Quality of SMC Surfaces: Paintability Enhanced
...ero. Lincoln Navigator bonnets went from a monthly average of over 100 C/1000 to less than five. The Navigator mudguards dropped from greater than 250 to down below three C/1000. Mustang mudguards and boot lids were producing upwards of 50 C/1000 and have dropped to the point where Ford has suspended collection of paint pop data. The rate for the Econoline mudguard dropped from over 100 to near zero. The Ford F-150 flareside mudguards launched with TCA and have been running at zero C/1000. The s...
Kunststoffe international, 2016-10-17, Polyamide 6 and 66 (PA6 and PA66)
...d increasingly carbon-fiber, based compounds specially tailored to the application are now available to the automotive industry. A vivid example of the viability of this concept is the grille opening reinforcement for the 2016 Ford Mustang Shelby GT350 developed by Magna International. It is injection molded from Ultramid A3WC4, a PA66 from BASF reinforced with 20 % carbon fibers. The use of the compound reduces the weight of the original plastic-metal hybrid part by a further 25 % (Title figure...
Additional information about this tradename, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.
Note: the information in Material Data Center was collected with maximum care, based on information from material producers. They are subject to short term changes at the market. There is no warranty for the correctness of this information. In no way this information can be seen as a legal advice, whether certain tradenames are protected or not.