Magnum - ABS - Trinseo

Kunststoffe international, 2005-11-21, Engineering Plastics: Products for Innovative Processes
...is also suitable for injection moulding, the blow moulded component can be combined with mountings as well as injection moulded and welded-on parts such as pipe or sensor connections. Styrene Copolymers and Blends (ABS, ASA) Dow has developed the Magnum Shield product family for applications requiring high impact strength, even at low temperature. These grades achieve very high impact strength values, while offering comparable processability and esthetics to standard ABS grades. For expansion ...

Kunststoffe international, 2005-11-21, Mould Design: Safely Warp-free
...at this creates. With the armrest folded down, the panel in the rear-seat backrest becomes accessible. The ski bag can be drawn out after the cover in the panel is opened (Fig.2). The injection-moulded parts of the cover and panel are made of ABS Magnum from Dow, supplied by Resin Express GmbH, Zwingenberg/Germany. Injection Mould for Warp-free Panels . . . The panel, injection moulded by Coko-Werk GmbH+Co. KG, Bad Salzuflen/Germany, as part of the interior trim, must meet high demands on its ...

Kunststoffe international, 2014-01-23, Trend Report: A Sector with Plenty of Potential
...he line’s turner bar system has been made more compact, allowing approx. 1.5 m to be shaved off its height. A 3-layer blown film line capable of producing up to 750 kg/h was presented by Dolci Extrusion S.r.l., Biassono, Italy. The new SXO Magnum winder for film widths of 2,200 mm has a taper tension system and supports gap winding. The new internalcooling controller features software for simplifying product changes. Measures to reduce condensation in the air rings have been implemented by Plast...