Complete Set of CAMPUS® Data, ASTM Data, Biopolymer Database, Application Database, Tradename Database, Literature Database, Toolbox.

Material datasheets available free. Online registration at: www.materialdatacenter.com

Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.

This is the free Material Data Center Datasheet of Xyron™ EV103 - (PP+PPE) - Asahi Kasei

Material Data Center offers the following functions for Xyron™ EV103:
unit conversion, PDF datasheet print, comparison with other plastics

Check here, which other Xyron datasheets, application examples or technical articles are available in Material Data Center

Use the following short links to get directly to the properties of interest in this datasheet:
Any use of this information falls under the rules of our disclaimer.
机械性能价值单位Test Standard
ISO数据
拉伸强度 37 MPa ISO 527
弯曲模量, 23°C 2050 MPa ISO 178
弯曲强度 57 MPa ISO 178
简支梁缺口冲击强度, +23°C 19 kJ/m² ISO 179/1eA
热性能价值单位Test Standard
ISO数据
线性热膨胀系数, 平行 90 E-6/K ISO 11359-1/-2
ASTM数据
DTUL @ 264 psi 97 °C ASTM D 648
电性能价值单位Test Standard
ISO数据
相对介电常数, 100Hz 2.3 - IEC 62631-2-1
相对介电常数, 1MHz 2.3 - IEC 62631-2-1
介质损耗因子, 100Hz 2 E-4 IEC 62631-2-1
介质损耗因子, 1MHz 5 E-4 IEC 62631-2-1
体积电阻率 8.4E14 Ohm*m IEC 62631-3-1
介电强度 30 kV/mm IEC 60243-1
其它性能价值单位Test Standard
密度 930 kg/m³ ISO 1183
加工推荐(注塑)价值单位Test Standard
预干燥-温度 80 - 90 °C -
预干燥-时间 1 - 2 h -
注塑熔体温度 230 - 260 °C -
模具温度 50 - 70 °C -
典型数据
加工方法
注塑
地区供应
北美, 欧洲, 亚太
权利义务的法律声明
Copyright Altair Engineering GmbH. Altair Engineering GmbH assumes no liability for the system to be free of errors. The user takes sole responsibility for the use of this data under the exclusion of every liability from Altair Engineering GmbH; this is especially valid for claims of compensation resulting from consequential damages. Altair explicitly points out that any decision about the application of materials must be double checked with the producer of this material. This includes all contents of this system. Copyright laws are applicable for the content of this system.
Created: Source: www.materialdatacenter.com


Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.

Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.