Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.
This is the free Material Data Center Datasheet of SABIC® PP PHC28 - PP - Saudi Basic Industries Corporation (SABIC)
Material Data Center offers the following functions for SABIC® PP PHC28:
unit conversion, PDF datasheet print, comparison with other plastics, snap fit calculation, beam deflection calculation, CAE Interfaces
Check here, which other Sabic datasheets, application examples or technical articles are available in Material Data Center
Use the following short links to get directly to the properties of interest in this datasheet:
Любая форма использования представленной информации должна осуществляться на основании заявленных
условий и с учетом отсутствия ответственности создателей системы.
Описание продукта
SABIC® PP PHC28 is the new development of SABICs very high impact PHC series. The grade combines very high impact resistance, also at low temperatures, with a good stiffness and offers very good flow properties. By its design it is offering potential of cycle time reduction, of down gauging and easiness of processing. PHC28 is typically used for injection moulding of applications requiring high impact from low to thick wall thickness such as suitcase shells, electronic equipment and automotive parts. SABIC® PP PHC28 is putting the combined stiffness and flow of very high impact copolymers to a next level.
Health, Safety and Food Contact regulations:Material Safety Data Sheets (MSDS) and Product Safety declarations are available on our Internet site
http://www.SABIC.com. The product mentioned herein is in particular not tested and therefore not validated for use in pharmaceutical/medical applications.
| Механические свойства | Значение | Единица | Стандарт |
| Данные ISO |
| Модуль упругости при растяжении |
1100 |
МПа |
ISO 527 |
| Напряжение в точке текучести |
21 |
МПа |
ISO 527 |
| Удлинение в точке текучести |
6 |
% |
ISO 527 |
| Ударная прочность по Шарпи с надрезом, +23°C |
60 |
кДж/м2 |
ISO 179/1eA |
| Ударная вязкость по Изоду образцов с надрезом |
7 |
кДж/м2 |
ISO 180/1A |
Особые свойства и характеристики
Способы переработки
Литье под давлением
Специальные характеристики
Сополимер
Сертификаты
Контакт с пищей
Дискламация
Copyright Altair Engineering GmbH. Altair Engineering GmbH assumes no liability for the system to be free of errors. The user takes sole responsibility for the use of this data under the exclusion of every liability from Altair Engineering GmbH; this is especially valid for claims of compensation resulting from consequential damages. Altair explicitly points out that any decision about the application of materials must be double checked with the producer of this material. This includes all contents of this system. Copyright laws are applicable for the content of this system.
Создан: Источник: www.materialdatacenter.com
Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.
Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.
