Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.

This is the free Material Data Center Datasheet of DURAFIDE® 1140A64 - PPS-GF40 - Polyplastics

Check here, which other Durafide datasheets, application examples or technical articles are available in Material Data Center

Propriedades mecânicas - Propriedades térmicas - Propriedades elétricas - Outras propriedades - Diagrama

Any use of this information falls under the rules of our disclaimer.

Propriedades mecânicas	Valor	Unidade	Método de ensaio
ISO Dados
Resistência à tração	200	MPa	ISO 527
Deformação na ruptura	1.8	%	ISO 527
Módulo de flexão, 23°C	15000	MPa	ISO 178
Resistência à flexão	300	MPa	ISO 178
Res. impacto Charpy c/entalhe, +23°C	10	kJ/m²	ISO 179/1eA
Dureza Rockwell	M 105	-	ISO 2039-2

Propriedades térmicas	Valor	Unidade	Método de ensaio
ISO Dados
Temperatura de deflexão térmica, 1.80 MPa	270	°C	ISO 75-1/-2
Coef. de expansão térmica linear, paralelo	20	E-6/K	ISO 11359-1/-2
Coef. de expansão térmica linear, perpend.	40	E-6/K	ISO 11359-1/-2
Flamabilidade a espessura h	V-0	class	IEC 60695-11-10
Cartão Amarelo (yellow card) disponível	sim	-	-

Propriedades elétricas	Valor	Unidade	Método de ensaio
ISO Dados
Constante dielétrica, 1MHz	4.5	-	IEC 62631-2-1
Fator de dissipação dielétrica, 1MHz	20	E-4	IEC 62631-2-1
Resistividade volumétrica específica	4E14	Ohm*m	IEC 62631-3-1
Resistência elétrica	16	kV/mm	IEC 60243-1
Índice comparativo de linha de fuga	150	-	IEC 60112
ASTM Dados
Resistência ao arco	123	s	ASTM D 495

Outras propriedades	Valor	Unidade	Método de ensaio
Densidade	1660	kg/m³	ISO 1183

Diagrama

Características

Disponibilidade regional

Ásia Pacífico

Disclaimer

Copyright Altair Engineering GmbH. Altair Engineering GmbH assumes no liability for the system to be free of errors. The user takes sole responsibility for the use of this data under the exclusion of every liability from Altair Engineering GmbH; this is especially valid for claims of compensation resulting from consequential damages. Altair explicitly points out that any decision about the application of materials must be double checked with the producer of this material. This includes all contents of this system. Copyright laws are applicable for the content of this system.

Created: Source: www.materialdatacenter.com

Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.

Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.