Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.
This is the free Material Data Center Datasheet of ALFATER XL A80 2EC0000 - TPV - MOCOM Compounds GmbH & Co. KG
unit conversion, PDF datasheet print, comparison with other plastics
Check here, which other Alfater datasheets, application examples or technical articles are available in Material Data Center
Base Polymer | Thermoplastic Vulcanisate (PP+EPDM) |
Colour | black |
Service Temperature | max. range (depending on load, geometry, etc.) -40-125 °C |
Special Features | electrically conductive,reduced surface resistivity,good weathering resistance,good chemical resistance,good ozone reistance,good hot air resistance,good hydrolysis resistant |
Market Segment | Automotive,Machinery,electrical and electronic,building and construction |
Application Area | injection moulded parts,extruded parts,coextrusion |
Typical Applications | functional components with electrical conductivity,seals,sealing lip,profile,2K components |
Adhesion to | Polypropylene Homopolymer,Polypropylene Copolymer,Polyethylene,Thermoplastic Vulcanisate (PP+EPDM),Thermoplastic Olefin Elastomer,Thermoplastic Elastomer general |
기계적 특성 | 값 | 단위 | 시험규격 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
ISO 데이터 | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
전단강도 | 40 | kN/m | ISO 34-1 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
쇼어 A 경도 | 80 | - | ISO 7619-1 |
기타 특성 | 값 | 단위 | 시험규격 |
밀도 | 1000 | kg/m³ | ISO 1183 |
Pre-Drying Conditions | in a dry air (dessiccant) dryer 70-80 °C for 2-4 h max. moisture content <0,10 % |
Processing Injection Moulding | melt temperature 195-230 °C mould temperature 10-60 °C injection speed high back pressure (hydraulic) >5 bar holding pressure 50-70% of injection pressure |
Processing Extrusion | melt temperature 200-240 °C die temperature 200-230 °C |
Storage | dry, protected from light not above 30°C tightly sealed |
Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.
Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.