Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.
This is the free Material Data Center Datasheet of ALFATER XL A80I 2FE0002 - TPV - MOCOM Compounds GmbH & Co. KG
unit conversion, PDF datasheet print, comparison with other plastics
Check here, which other Alfater datasheets, application examples or technical articles are available in Material Data Center
Base Polymer | Thermoplastic Vulcanisate (PP+EPDM) |
Colour | black |
Service Temperature | max. range (depending on load, geometry, etc.) -40-125 °C |
Special Features | high density,noise dampening,good weathering resistance,resistant to alkalis,good ozone reistance,good hot air resistance,good hydrolysis resistant |
Market Segment | Automotive,Machinery,building and construction,electrical and electronic |
Application Area | injection moulded parts |
Propriétés mécaniques | Valeur | Unité | Norme du test | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
ISO Data | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Résistance à la déchirure | 17 | kN/m | ISO 34-1 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Dureté Shore A | 80 | - | ISO 7619-1 |
Propriétés diverses | Valeur | Unité | Norme du test |
Masse volumique | 2100 | kg/m³ | ISO 1183 |
Pre-Drying Conditions | in a dry air (dessiccant) dryer for 2-4 h max. moisture content <0,10 % |
Processing Injection Moulding | melt temperature 195-230 °C mould temperature 10-70 °C injection speed high |
Storage | dry, protected from light not above 30°C tightly sealed |
Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.
Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.