Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.
This is the free Material Data Center Datasheet of ALCOM PA6 900/1 GF20 SV1180-10MCF - PA6-GF20... - MOCOM Compounds GmbH & Co. KG
unit conversion, PDF datasheet print, comparison with other plastics, snap fit calculation, beam deflection calculation, CAE Interfaces
Check here, which other Alcom datasheets, application examples or technical articles are available in Material Data Center
Base Polymer | Polyamide 6 |
Filler/Additive System | 20 % glass fibres |
Special Features | metallic effect,low tendency to flow lines |
Market Segment | Automotive,Machinery,electrical and electronic |
Typical Applications | housings |
Propiedades mecánicas | Seco / Cond | Unidades | Método de ensayo | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
ISO Data | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Módulo de tracción | 7200 / - | MPa | ISO 527 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Resistencia a la tracción | 115 / - | MPa | ISO 527 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Alargamiento a rotura | 3 / - | % | ISO 527 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Resistencia al impacto Charpy, +23°C | 40 / - | kJ/m² | ISO 179/1eU | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Resistencia al impacto Charpy c/entalla, +23°C | 6.5 / - | kJ/m² | ISO 179/1eA |
Propiedades térmicas | Seco / Cond | Unidades | Método de ensayo | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
ISO Data | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Estabilidad al calor, 1.80 MPa | 205 / * | °C | ISO 75-1/-2 |
Otras propiedades | Seco / Cond | Unidades | Método de ensayo |
Densidad | 1320 / - | kg/m³ | ISO 1183 |
Pre-Drying Conditions | in a dry air (dessiccant) dryer >80 °C for 2-12 h dependant on moisture content |
Processing Injection Moulding | melt temperature 270-290 °C mould temperature 80-100 °C |
Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.
Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.