Complete Set of CAMPUS® Data, ASTM Data, Biopolymer Database, Application Database, Tradename Database, Literature Database, Toolbox.

Material datasheets available free. Online registration at: www.materialdatacenter.com

Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.

This is the free Material Data Center Datasheet of RTP 3400 G-445 - LCP-GF - RTP Company

Material Data Center offers the following functions for RTP 3400 G-445:
unit conversion, PDF datasheet print, comparison with other plastics

Check here, which other RTP datasheets, application examples or technical articles are available in Material Data Center

Use the following short links to get directly to the properties of interest in this datasheet:
Any use of this information falls under the rules of our disclaimer.
Processing/Physical CharacteristicsValueUnitTest Standard
ASTM Data
Mold Shrinkage, MD 0.001 mm/mm ASTM D 955
Mechanical propertiesValueUnitTest Standard
ASTM Data
Tensile Modulus 15170 MPa ASTM D 638
Tensile Strength 110 MPa ASTM D 638
Flexural Modulus 13790 MPa ASTM D 790
Flexural Strength 152 MPa ASTM D 790
Izod Impact notched, 1/8 in 74.7 J/m ASTM D 256
Thermal propertiesValueUnitTest Standard
ASTM Data
UL 94 Flame rating V-0 - UL 94
Thickness tested 0.794 mm -
DTUL @ 264 psi 299 °C ASTM D 648
Electrical propertiesValueUnitTest Standard
ASTM Data
Dielectric Strength, Short Time 35.4 kV/mm ASTM D 149
Dissipation Factor, 1 MHz 0.031 - ASTM D 150
Dielectric Constant, 1 MHz 3.4 - ASTM D 150
Other propertiesValueUnitTest Standard
Water Absorption, 24hr 0.1 % ASTM D 570
Density 1750 kg/m³ ASTM D 792
Processing Recommendation Injection MoldingValueUnitTest Standard
Pre-drying - Temperature 149 °C -
Pre-drying - Time 8 h -
Melt temperature 363 - 399 °C -
Mold temperature 65.6 - 93.3 °C -
Injection pressure 68.9 - 124 MPa -
Characteristics
Processing
Injection Molding
Special Characteristics
Flame retardant
Regional Availability
North America, Europe, Asia Pacific
Disclaimer
Copyright Altair Engineering GmbH. Altair Engineering GmbH assumes no liability for the system to be free of errors. The user takes sole responsibility for the use of this data under the exclusion of every liability from Altair Engineering GmbH; this is especially valid for claims of compensation resulting from consequential damages. Altair explicitly points out that any decision about the application of materials must be double checked with the producer of this material. This includes all contents of this system. Copyright laws are applicable for the content of this system.
Created: Source: www.materialdatacenter.com


Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.

Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.