Complete Set of CAMPUS® Data, ASTM Data, Biopolymer Database, Application Database, Tradename Database, Literature Database, Toolbox.

Material datasheets available free. Online registration at: www.materialdatacenter.com

Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.

This is the free Material Data Center Datasheet of Halene - H HD T6 - (PE-HD) - Haldia Petrochemicals

Material Data Center offers the following functions for Halene - H HD T6:
unit conversion, PDF datasheet print, comparison with other plastics

Check here, which other Halene datasheets, application examples or technical articles are available in Material Data Center

Use the following short links to get directly to the properties of interest in this datasheet:
Processing/Physical Characteristics - Mechanical properties - Thermal properties - Other properties - Processing Recommendation Extrusion
Any use of this information falls under the rules of our disclaimer.
Product Texts
HD T6 is a general-purpose extrusion & lamination film HDPE grade produced by the Mitsui CX Technology.

HD T6 can be used for Lamination films, Woven sacks and Tarpaulin.

This grade is characterized by good processability and mechanical strength.
Processing/Physical CharacteristicsValueUnitTest Standard
ASTM Data
Melt Flow Index, MFI 0.5 g/10min ASTM D 1238
Temperature 190 °C -
Load 2.16 kg -
Mechanical propertiesValueUnitTest Standard
ASTM Data
Tensile Strength at Yield 30 MPa ASTM D 638
Tensile Strength at Break 38 MPa ASTM D 638
Elongation at Break 800 % ASTM D 638
Flexural Modulus 1150 MPa ASTM D 790
Shore D Hardness 65 - ASTM D 2240
Izod Impact notched, 1/8 in 250 J/m ASTM D 256
Thermal propertiesValueUnitTest Standard
ASTM Data
Melting Temperature 131 °C ASTM D 3418
Vicat Temperature 124 °C ASTM D 1525
Other propertiesValueUnitTest Standard
Density 960 kg/m³ ASTM D 792
Processing Recommendation ExtrusionValueUnitTest Standard
Zone 1 200 - 240 °C -
Nozzle temperature 220 - 240 °C -
Characteristics
Processing
Film Extrusion, Other Extrusion
Applications
General Purpose
Regional Availability
Asia Pacific
Disclaimer
Copyright Altair Engineering GmbH. Altair Engineering GmbH assumes no liability for the system to be free of errors. The user takes sole responsibility for the use of this data under the exclusion of every liability from Altair Engineering GmbH; this is especially valid for claims of compensation resulting from consequential damages. Altair explicitly points out that any decision about the application of materials must be double checked with the producer of this material. This includes all contents of this system. Copyright laws are applicable for the content of this system.
Created: Source: www.materialdatacenter.com


Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.

Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.