Complete Set of CAMPUS® Data, ASTM Data, Biopolymer Database, Application Database, Tradename Database, Literature Database, Toolbox.

Material datasheets available free. Online registration at: www.materialdatacenter.com

Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.

This is the free Material Data Center Datasheet of SABIC® LLDPE 324CE - (PE-LLD) - Saudi Basic Industries Corporation (SABIC)

Material Data Center offers the following functions for SABIC® LLDPE 324CE:
unit conversion, PDF datasheet print, comparison with other plastics

Check here, which other Sabic datasheets, application examples or technical articles are available in Material Data Center

Use the following short links to get directly to the properties of interest in this datasheet:
Mechanical properties - Electrical properties
Any use of this information falls under the rules of our disclaimer.
Product Texts
SABIC® LLDPE 324CE is a Linear Low Density Polyethylene natural resin typically used for wire and cable applications. SABIC® LLDPE 324CE contains a low level of antioxidants and does not contain any antiblock and/or slip agents. It also exhibits good Environmental Stress Crack Resistance (ESCR). Sufficient Cu-inhibitor should be added to meet specific ageing requirements. For jacketing applications, addition of Carbon Black or UV stabilizer is required. Applications - Telecommunication and Power cable (LV, MV, HV) jacketing. - Halogen-free flame retardant (HFFR) compounds. - One-step or two-steps silane crosslinkable for cable insulation. This product is not intended for and must not be used in any pharmaceutical/medical applications. Mechanical and electrical properties. Test specimens were prepared by compression moulding according to ASTM D 4703.
Mechanical propertiesValueUnitTest Standard
ISO Data
Yield stress 13 MPa ISO 527
Yield strain 21 % ISO 527
Stress at break 22 MPa ISO 527
Strain at break >50 % ISO 527
Flexural modulus, 23°C 500 MPa ISO 178
Shore D hardness 53 - ISO 7619-1
Electrical propertiesValueUnitTest Standard
ASTM Data
Dissipation Factor, 60 Hz 0.0005 - ASTM D 150
Dielectric Constant, 60 Hz 2.2 - ASTM D 150
Volume Resistivity >1E15 Ohm*cm ASTM D 257
Characteristics
Special Characteristics
Flame retardant, Halogen-free, U.V. stabilized or stable to weather
Disclaimer
Copyright Altair Engineering GmbH. Altair Engineering GmbH assumes no liability for the system to be free of errors. The user takes sole responsibility for the use of this data under the exclusion of every liability from Altair Engineering GmbH; this is especially valid for claims of compensation resulting from consequential damages. Altair explicitly points out that any decision about the application of materials must be double checked with the producer of this material. This includes all contents of this system. Copyright laws are applicable for the content of this system.
Created: Source: www.materialdatacenter.com


Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.

Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.